Frame
Control Board
- ArduPilot Mega 2.6
- uBlox LEA-6H GPS with Compass
- GPS Mast for uBlox LEA-6H
- Power Module for ArduPilot (4S)
Motors
- Turnigy Multistar 2814-800Kv 123 (HobbyKing didn’t stock the 2814-800Kv so I pulled the trigger on the smaller 2214-800Kv, not ideal as the motor mounts don’t all line up but close enough, in hindsight should have waited for the 2814-800Kv)
- NTM 28 Carbon Fibre Motor Mount (as above, used the cross mount from this kit to mount the Turnigy motors with holes 16mm & 19mm to the Predator 650 motors mounts with holes 19mm & 25mm, no motor mount screws are provided so used screws scavenged from previous builds to mount the the cross mount to the motor mounts, if you get the 2814-800Kv motors mentioned above you mount directly onto the motor mounts)
Speed Controllers
Propellors
- 12 x 4.5 Slow Fly Nylon Propellers (Scavenged from retired X525 build)
Battery
Radio
- Turnigy 9XR Transmitter Mode 1 (No Module) (Scavenged from retired X525 build)
- FrSky DF 2.4Ghz Combo Pack for JR w/ Module & RX (Scavenged from retired X525 build)
- 3DR Radio Set (433mhz for Europe) (Scavenged from retired X525 build)
FPV
- Fatshark 600TVL High Resolution FPV Tuned CMOS Camera
- BOSCAM 5.8Ghz 8-channel 200Mw video transmitter
- BOSCAM 5.8Ghz 8-channel FPV goggles (superseded by Skyzone 5.8GHz FPV Goggles)
Miscellaneous
- Signal loss Alarm & Lost Plane Finder
- On-Board Lipoly Low Voltage Alarm 2s~3s
- Wire Mesh Guard Black 10mm (use the mesh to protect the motor leads when exposed at the end of each motor mount)
- 3.5mm Male/Female Bullet Brushless Motor Extension Lead 200mm